c i r k a

Table of Contents

boatyard

rudder (pre-engine removal)

  • verify tiller angle/sweep obstructions
    • test against proposed cockpit backrests
  • measurements for tiller → rudder attachment bracket design
  • remove from boat

remove engine

  • remove from boat
  • crane
    • Danish Marine - 503-289-1436
  • remove driveshaft, cutlass bearing
  • remove/redesign skeg?

rudder

  • verify/reshape to design profile if necessary
    • sand, surface & prep for paint
  • design/install windvane attachment points onto rudder
  • cut in new door
  • patch aft opening
  • install head/nav station bulkhead
  • prep head floor & shower pump
  • remove seacock, patch hull

propane locker

  • design/construct deck surface hatch
  • design/construct container

misc

  • demo existing depth transducer
    • confirm sizing for new transducer housing
  • measure port hole spacing
    • re-mark/cut for new spacing/symmetry

supplies

  • chain hoist, trolley, ibeam
  • crane
  • SS hardware for propane access hatch

shop/home

  • buy/setup bandsaw
  • new bandsaw outlet
    • same circuit as table saw - convert to 220V?
  • build frame (with hinges) for sewing machine
  • test water pump
  • test instruments
  • bottle opener on plate steel geometry?
boat/maytasks.txt · Last modified: by 127.0.0.1
Show pagesourceOld revisionsRecent ChangesSitemap
Back to top